Configuration
5 Configuration
Wireless sensors are registered or deleted and further device configuration functions are performed
by pressing the programming button for a certain length of time whilst observing the visual confir-
mation via the LEDs.
The programming button is located inside the housing of the device and is only accessible after
opening the housing. (To open the housing, see chapter 4.3)
Programming
button
Figure 6:
View of the programming button
When doing this, pay attention to the safety instructions for the handling of subassemblies contain-
ing electrostatically sensitive devices (ESDs). (See safety instructions in Chapter 1)
In order to select a certain function, press and
hold
the programming button
until
the desired func-
tion is signalled by the LEDs. Then release the programming button. Distinction must thereby be
made between flashing and steadily lit LEDs.
The programming cycle is circular and requires approx. 71 seconds for a complete circuit.
How are the func-
tions selected?
In order to exit from the programming cycle, you can either go through the cycle until the end or
briefly remove the central plug. Settings that have already been made will be retained.
How can I exit from
the programming
mode?
An overview of the functions that can be called via the programming button can be found below:
© 2010 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · E-mail: [email protected]
23
/37
21-810-19-0003_421830_en (Rev A).doc / 2010-08-31 / Issue A / rk.