Hirschmann iFLEX TRS 14, User Manual, Page: 15 / 37

Installation
Please follow the instructions below for laying the antenna cable:
How should the
cable be laid?
IMPORTANT
The antenna cable can be damaged if it is squeezed or kinked.
Therefore, lay the antenna cable in such a way that it is neither squeezed nor laid around
sharp edges!
IMPORTANT
The function of the antenna and hence the whole system can be impaired if a mismatching
antenna radiator is used.
Always use the antenna radiator contained in the scope of supply!
After laying the cable, connect the coaxial connector of the antenna to the antenna socket on the
underside of the
iFLEX TRS 14
. Screw the connector on hand tight.
Where is the an-
tenna
connected?
3.2 Electrical connection
Connection of the device is simple thanks to the connecting cable (4,7 m), which is prefabricated at
one end and included in the scope of supply. The open cable end is to be connected properly using
wire end ferrules. Please refer to the following illustrations for the wiring of the connecting cable and
the pin configuration of the central plug.
CAUTION
Danger of electrical short-circuits.
Switch off all systems before commencing with the installation work!
IMPORTANT
Damage to the device if connected to an unsuitable power supply.
The device may only be connected to a DC voltage source of 10 V to 30 V!
© 2010 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · E-mail: info.ecs@hirschmann.de
15
/37
21-810-19-0003_421830_en (Rev A).doc / 2010-08-31 / Issue A / rk.