48
BAT-F, BAT-Rail, BAT54, BAT300
Release 02 07/10
2.15
Finding and configuring devices
Note: Apply power to the device before starting the computer for the
configuration.
AP / AC devices can be configured in the following ways (if the model is
equipped with the corresponding interface):
X
Via the local network (LAN).
X
Via the radio network (WLAN), if the WLAN encryption (e.g. WPA2) in a
device with a wireless interface and in the configuration computer is set
or deactivated respectively.
X
Via the serial configuration interface.
Refer to ”ConneXium WiFi TCSG,TSCN Configuration and Administration
Guide” on the CD ROM for more details.
2.16
Installing external antennas
External antennas are required to operate the access point.
You will find an overview of the antennas that are supported and can be
connected, along with the corresponding technical data, at www.schneider-
electric.com.
When installing external antennas, adhere to the regulations of the
country in which you are operating the WLAN device, and to the general
operating permission and the maximum emission levels.
Transmission power
The operator of a WLAN radio installation must adhere to the applicable
transmission threshold values.
Use the LANconfig or the Webconfig to start the configuration of the
device. (This software is located on the CD provided.)
Go to the settings for Wireless LAN.
Enter the country in which you are installing the device (see the
following figure):
