Installation Instructions for:
105295-HEI Kit
Gen1 to Gen5
Control System
Changing the Software
Configuration
IMPORTANT
Perform this procedure on a solid level surface
with the platform in the stowed position.
1. Pull out the red Emergency Stop button to the on
position at the ground controls.
2. Push in the red Emergency Stop button to the off
position at the platform controls.
3. Turn the key switch to platform control.
4. At the platform controls, press and hold the lift
function select and speed select buttons, and pull
out the red Emergency Stop button to the on
position.
Outcome: The diagnostic display at the platform
controls and the ECM, will show “SC”.
5. Release the lift function select and speed select
buttons.
Outcome: The diagnostic display will show the
current configuration.
6. Press the lift function select button.
Outcome: The “tens” digit setting will be activated and
the current “tens” setting will flash in the diagnostic
display. Use the steering thumb rocker switch on the
joystick to increase or decrease the value. Refer to
the Configuration Code Chart for configuration
settings.
7. Press and hold the lift function select button for a
minimum of 3 seconds to set the “tens” value.
8. Press the speed select button.
Outcome: The “ones” digit setting will be activated
and the current “ones” setting will flash in the
diagnostic display. Use the steering thumb rocker
switch on the joystick to increase or decrease the
value. Refer to the Configuration Code Chart for
configuration settings.
9. Press and hold the speed select button for a
minimum of 3 seconds to set the “ones” value.
10. Turn the key switch to the off position to allow the
settings take effect.
11. Perform the function tests. Refer to the operator's
manual for your machine.
12. The procedure is complete.
a
Joystick Controller with Thumb
Steering Rocker
b
Lift Function Select Button
c
Diagnostic Display
d
Red Emergency Stop Button
e
Speed Select Button
P/N 105294-HEI Rev.0
HEI
7/ 16
