HIMA HIMatrix CIO 2/4 01, Manual

Page: 25 / 40

CIO 2/4 01 4 Start-Up
HI 800 199 E Rev. 1.00 Page 25 of 40
4.3.2.2 CIO 2/4 01_1: Channels
Tab
The
CIO 2/4 01_1 Channels
tab contains the following system parameters:
System parameter Data
type R/W Description
-> Error Code
[BYTE] BYTE R Error codes for the digital output channels
Coding Description
0x01 Module fault
0x02 Channel shutdown due to overload
0x04 Error while reading back the digital outputs
Value [BOOL] -> BOOL W Output values of the digital output channels
0: Output de-energized
1: Output energized
Table 17: SILworX - System Parameters of the Counters and Outputs,
CIO 2/4 01_1:Channels
Tab
4.4 Configuring a Module Using ELOP II Factory
4.4.1 Configuring the Inputs and Outputs
The signals previously defined in the Signal Editor (Hardware Management) are assigned
to the individual channels (inputs and outputs) using ELOP II Factory. Refer to the System
Manual for Compact Systems or the online help for more details.
The following chapter describes the system signals used for assigning signals in the
controller.
4.4.2 Signals and Error Codes for the Inputs and Outputs
The following tables specify the system signals that can be read and set for the inputs and
outputs, including the corresponding error codes.
In the user program, the error codes can be read using the signals assigned within the
logic.
The error codes can also be displayed in ELOP II Factory.
4.4.3 Counter CIO 2/4 01
System Signal R/W Description
Mod.SRS [UDINT] R Slot number (System Rack Slot)
Mod. Type [UINT] R Type of module,target value: 0xFC03 [64515
dez
]
Mod. Error Code
[WORD] R Module error code
Coding Description
0x0000
I/O processing, if required with errors, see other error
codes
0x0001 No I/O processing (CPU not in RUN)
0x0002 No I/O processing during the booting test
0x0004 Manufacturer interface operating
0x0010 No I/O processing: wrong configuration
0x0020 No I/O processing: fault rate exceeded
0x0040/
0x0080 No I/O processing: configured module not plugged in