Hilti TE 500-X, Operating Instructions Manual

Page: 12 / 20

8 English
5.4 Fitting the side handle (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and into the recess provided.
3. Adjust the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.5 Types of work
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶
Check the appliance’s supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
Check extension cords at regular intervals and replace them if found to be damaged.
5.5.1 Chiseling
1. Slowly press the control switch.
Running speed can be controlled smoothly up to maximum by varying how far the control switch
is pressed.
2. To switch the power tool off, release the control switch.
5.5.2 Switching on and off in sustained operating mode
When chiseling, the control switch can be locked in the “on” position.
Printed: 04.07.2019 | Doc-Nr: PUB / 5368075 / 000 / 03