![background image](http://html1.mh-extra.com/html/hilti/sjt-6-a22/sjt-6-a22_original-operating-instructions_2136178017.webp)
*2150257*
2150257
English
11
Trouble or fault
Possible cause
Action to be taken
The battery runs down more
quickly than usual.
Very low ambient temperature.
▶
Allow the battery to warm up
slowly to room temperature.
The battery doesn’t engage
with an audible click.
The retaining lugs on the battery
are dirty.
▶
Clean the retaining lugs and refit
the battery.
1 LED blinks.
The power tool doesn’t run.
Low battery.
▶
Change the battery and charge
the empty battery.
The battery is too hot or too cold.
▶
Allow the battery to cool down
or warm up slowly to room
temperature.
All 4 LEDs blink.
The power tool doesn’t run.
The tool has been overloaded.
▶
Release the on/off switch and
then press it again. Then allow
the power tool to run under no
load for approx. 30 seconds.
The power tool or battery
gets very hot.
Electrical fault.
▶
Switch the power tool off im-
mediately, remove the battery,
keep it under observation, allow
it to cool down and contact
Hilti
Service.
11
Disposal
Most of the materials from which
Hilti
tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to
Hilti
for recycling. Ask
Hilti
Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your
Hilti Store
, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
12
FCC statement (applicable in US) / IC statement (applicable in Canada)
This device complies with Part 15 of the FCC Rules and RSS-210 of lC. Operation is subject to the following
two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired
operation.
13
Manufacturer’s warranty
▶
Please contact your local
Hilti
representative if you have questions about the warranty conditions.
Printed: 10.09.2019 | Doc-Nr: PUB / 5378777 / 000 / 01
Summary of Contents for SJT 6-A22
