Hilti SJT 6-A22, Original Operating Instructions

Page: 16 / 56

10 English 2150257
*2150257*
8.1 Cleaning the suction adapter
1. Remove the battery.
2. Remove the suction adapter. → page 9
3. Clean the suction adapter.
4. Check that the catches are undamaged.
5. Fit the dust removal adapter. → page 8
8.2 Cleaning the saw blade
1. Clean resin deposits from used saw blades at regular intervals.
2. Place the saw blades in a bath of kerosene (paraffin oil) or commercially-available resin remover for 24
hours.
9 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶
Always transport your products with the batteries removed!
▶
Remove the battery.
▶
Never transport batteries in bulk form (loose, unprotected).
▶
Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the tool and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a window pane.
▶
Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶
Check the tool and batteries for damage before use after long periods of storage.
10 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The saw blade drops out. The saw blade is not correctly en-
gaged.
▶
Repeat the insertion procedure.
▶
Make sure that the blade holder
is fully open and that the saw
blade is pushed all the way in
against the spring resistance.
The clamping system is clogged
with foreign matter.
▶
Clean out the blade holder.
The saw blade cannot be
inserted.
The clamping system is clogged
with foreign matter.
▶
Clean out the blade holder.
The orbital action cannot be
adjusted.
Foreign matter in the orbital-action
adjusting lever groove.
▶
Clean out the orbital-action
adjusting lever groove.
The orbital action doesn’t
work.
The orbital-action mechanism is
clogged with foreign matter.
▶
Check whether foreign matter
is present in the area of the
orbital-action fork and clean it
out.
The orbital-action adjusting lever is
in position “0”.
▶
Adjust it to the desired setting.
Printed: 10.09.2019 | Doc-Nr: PUB / 5378777 / 000 / 01