Hilti SF(H) 18-A, Operating Instructions Manual

Page: 15 / 81

en
9
The power tool and its ancillary equipment may present hazards when used
incorrectly by untrained personnel or when used not as directed.
3.2 Standard equipment includes:
1 Power tool
1 Side handle
1 Operating instructions
NOTE
Approved accessories are available from your Hilti Center or can be ordered
online at www.hilti.com .
3.3 Additional items required for operating the tool
A suitable battery of the specified type (see table in the Technical Data
section) and a suitable battery charger from the C 4⁄36 series.
3.4 Charge state and overheating indicator display on the Li-ion bat-
tery
When the lithium-ion battery is in use, the charge status can be indicated
by gently pressing one of the battery release buttons (press until resistance
is felt - do not release the battery). The display on the rear of the battery
provides the following information:
LEDs light constantly LEDs blink Charge status C
LED 1, 2, 3, 4 - C ≧ 75 %
LED 1, 2, 3 - 50 % ≦ C < 75 %
LED 1, 2 - 25 % ≦ C < 50 %
LED 1 - 10 % ≦ C < 25 %
- LED 1 C < 10 %
- LED 1 The battery has over-
heated
NOTE
Indication of the charge status is not possible while the power tool is in
operation or immediately after operation. If the battery charge status LEDs
flash, please refer to the information given in the Troubleshooting section.
Printed: 22.06.2015 | Doc-Nr: PUB / 5070676 / 000 / 04