17
en
G
In case of gas contact with the skin: Wash the contact
surface carefully with warm water and soap and apply
a skin cream when dry.
G
Consult a doctor if necessary.
5.5 Requirements to be met by users
G
The tool is intended for professional use.
G
The tool may be operated, serviced and repaired only
by authorized, trained personnel. This personnel must
be informed of any special hazards that may be encoun-
tered.
G
Always concentrate on your work. Proceed carefully
and do not use the tool if your full attention is not on
the job.
5.6 Personal protective equipment
G
The operator and other persons in the immediate vicin-
ity must always wear eye protection, a hard hat and
ear protection while the tool is in use or when check-
ing the tool in case of a fault.
5.7 Safety devices
G
Never use the tool if the sliding sleeve (safety device)
is damaged or missing.
6. Before use
-WARNING-
The magazine must be empty.
The gas can must be removed from the can compart-
ment.
6.1 Inserting nails
1. Pull the nail pusher back until it engages.
-NOTE-
The nail pusher must engage.
2. Slide the nails into the magazine (maximum of 2 strips
of 10 nails).
3. Disengage the nail pusher and allow it to slide forward
slowly.
6.2 Preparing the gas can for use
1. Position the valve head on the inside edge of the gas
can.
2. Press the valve head onto the gas can until it engages.
-NOTE-
Check that the valve head is fitted correctly on the valve
seat. Slight play is normal.
-CAUTION-
Once the valve head has been fitted on the gas can it
should not be removed (except when the can is disposed
of).
6.3 Inserting the gas can
1. Open the cover of the gas can compartment on the
tool.
2. Slide the gas can into the can compartment, base first,
until it engages.
-NOTE-
The arrow on the valve head must point to the outside
and the white plate must be positioned toward the tool.
3. Close the cover of the gas can compartment and ensure
that it engages in the closed position.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069872 / 000 / 00
Summary of Contents for GX 100-E
