Hilti EXO-S, Original Operating Instructions

Page: 36 / 592

32 English 2339613
*2339613*
8 Optional accessories
8.1 Installing/removing neck support
1. Position the neck support on the mounts of the
shoulder strap.
2. Place your thumb on the ribbed surface and slide
the neck support down to engage it in the desired
position.
3. Check that the neck support is set to the same height
on both sides.
4. To remove the neck support, place your thumb on
the ribbed surface and slide the neck support up.
5. Clean the neck pad in the same way as the arm pads.
→ page 32
9 Care and maintenance
WARNING
Risk of injury caused by expanders under tension. Injuries during care and maintenance work.
▶ Carry out care and maintenance work only with the expanders at zero tension.
Care
• Carefully remove stubborn dirt from the tool.
• Do not clean the product with compressed air.
• Clean the product only with a slightly damp cloth and pH-neutral soap. Do not use cleaning agents
containing silicone as they can attack the plastic parts.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local
Hilti Store or online at: www.hilti.group .
9.1 Cleaning pads
1. Remove the pads from the arm supports.
2. Hand-wash the pads in water with pH-neutral soap.
3. Thoroughly rinse the pads.
4. Allow the pads to air-dry.
5. Reinstall the pads.