Hilti DST 10-CA, Operating Instructions Manual

Page: 37 / 52

*2328079*
2328079 English 33
+
Shouldered guide stud
§
Saw arm arbor
1. Remove the inner flange (normal cutting), if fitted. → page 39
2. Press the flange nut fully into the inner flange.
The inside face of the flange must form a flat surface. Install the flange only if
the flange nut is fully countersunk. Attempting installation with the flange nut
protruding can result is damage to the inner flange and mount.
3. If applicable, unscrew the 6 countersunk-head screws from the inner flange (1) .
4. Set the inner flange (flush cutting) on the saw blade (2) .
5. Screw the 6 countersunk-head screws into the face of the saw blade (3) .
6. Tighten the 6 countersunk-head screws to the specified torque (4) .
Technical data
Tightening torque (countersunk-head screws
M10 10.9)
15 Nm
7. Check that the inner flange is correctly installed.
7.4.4 Installing saw blade (flush-cut)
Before starting installation, switch the wall saw off at the on/off switch or press the
EMERGENCY STOP button.
Disconnect the supply cord plug from the power outlet.