Hilti DST 10-CA, Operating Instructions Manual

Page: 27 / 52

*2328079*
2328079 English 23
6. Fit end stops at the ends of the rail.
6.4 Mounting track on track supports for bevel cutting and adjusting cutting
angle
@
Leveling screw
;
Clamping plate with clamping
screw
=
Clamping screws for bevel-cut
angle
%
Slot for securing screw
1. Slacken the clamping screw for the clamp-
ing plate on all track supports.
2. Slacken the bottom clamping screw for the
bevel-cut angle.
To set a 45° cutting angle, the bottom
screw has to be completely removed
from the track support. Re-install the
screw after setting the track support
to 45 °.
3. Slacken the top clamping screw for the
bevel-cut angle.
4. Fit the track onto the track supports.
5. Slide the clamping plate over the edge of the track and tighten the plate clamping
screw.
6. Adjust the track to the desired cutting angle.
7. Retighten the clamping screws for the bevel-cut angle.
8. Check and adjust the offset distance of the track from the cutting line and then tighten
the track support securing screws.
Dimensions for setting up for angular cutting → page 24
9. Use the leveling screws to compensate for differences in level.
10.Fit end stops at the ends of the track.