44
Chapter 4 Boot and Configuration
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
Figure 4-2: Parameters for Terminal Session
3.
Switch on the power supply, and the appliance initializes the system
automatically. If the booting succeeds, the system will display the command line
prompt login. Enter the default administrator name and password “hillstone” at
the login and password prompts, press Enter. And now you are successfully
logged in and accessing the CLI.
4.
Enter commands to configure or view running status. Enter a question mark “?”
to get help on commands whenever you want.
WebUI
The ethernet0/0 (e0/0) port has a default IP address of 192.168.1.1/24, and all the
management functions of this port are enabled by default. Administrators can access
the WebUI through e0/0.
To log in the appliance’s WebUI, take the following steps:
1.
Set up the IP address of the management PC on the same network section as
192.168.1.1/24. Connect the management PC to the e0/0 port through an
Ethernet cable.
2.
Launch a Web browser of the management PC, enter the URL
http://192.168.1.1 in the address bar, and then press Enter.
3.
Enter the default administrator name and password (hillstone/hillstone) in
the Login and Password text boxes.
