40
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
♦
Be careful not to connect the Ethernet port to the wrong ports. Read the label
above the port carefully.
♦
For SFP port connection, the optical module should be inserted into SFP port
before installing the LC-type connector to the optical module; the copper SFP
module should be connected by crossover cable or straight-through cable.
♦
For XFP ports, insert the XFP optical module into the XFP port before connecting
the LC-type connector to the module.
Keep the followings in mind when connecting fiber cables:
♦
The curvature radius should be greater than 10cm. Avoid excessive bending of
the cable.
♦
Ensure the Tx and Rx ends are connected correctly.
♦
Keep the connector of the optical cable clean.
Figure 3-14: Connecting the Ethernet Copper Cable
Warning: Laser danger! To protect your eyes from radiation harm, do not stare into a
cable connector connected to a laser.
Connecting an AC Power Cable
The AC power cable is shipped with the chassis.
To connect the AC power cable, take the following steps:
1.
Take the AC power cable out of the accessory box.
