11
Assembly
Step 7 – Adjusting the width of your Supa Fold
Your Supa
Fold width can be reduced to suit your specific installation needs or to align
with existing stud centres.
The standard mount hole centres for your Supa
Fold model are shown in the table
on page 5.
Determine the length you need to reduce your product, halve this amount and cut equal
lengths from the ends of the assembled spreader with a hacksaw (
Fig. 12
).
•
Cutting equal amounts from each end of the spreader will maintain the
spreader handle in the centre of the product.
•
Be careful when cutting with a hacksaw, ensure you do not slip/damage the
powdercoat and keep the cut edge square. You may need to clean up the
edges with a file after cutting.
•
Make sure the inside of the cut edges are smooth to allow the corners to slide
in easily.
Fig. 12
Cut equal lengths
from each end
