12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service:
800-626-1126
BLUM REDUCED DEPTH SINGLE 35 QT WASTE CONTAINER
Center line of cabinet
Edge of paper to back of door
Edge of paper to back of door
Fold
her
e
to
fit
into
cabinet
opening
Fold
her
e
to
fit
into
cabinet
opening
Assembly (Fig.1)
1. Remove the slide triggers from their wrapping.
2. Turn your wood box over and locate the pre-drilled holes on the front
lip of the box, refer to Fig.1 for help locating.
3. Using the provided screws, attach your left and right sided triggers and
set wood box to the side.
NOTE
Release triggers are side sensitive and are marked with an “L” & “R” for Left and Right.
Marking slide hole locations
1. Place template into cabinet and position front edge to where the back
of your door will be.
a. Inset door = set back the thickness of your door
b. Overlay = place at the front edge of cabinet
2. Using an awl or pencil, mark through the bold dotted screw locations
onto your cabinet floor.
a. Remove template when done.
3. Lay your assembled slide set over the top of the marked hole; using
the provided screws, attach the slides to the cabinet floor through the
slotted holes on the strap pieces.
4. Place your wood box with attached triggers on top of the slides and
push back until you hear the “click” sound.
Door Mounting (Fig. 2)
1. Begin by loosening four nuts with 10mm nut driver and slide brackets
out to desired location.
NOTE
Be sure you are mounting to thick portion of door.
2. Using provided screws, attach your door to wood frame.
3. Slide door either left or right for proper alignment. Tighten once set.
4. Adjust four micro-screws for door tilt adjustment.
NOTE
10mm nut must be loose when adjusting tilt. Secure tightly once adjustments
have been made.
12”
3”
Floor of
cabinet
FIG.
1
FIG.
2
Pre-drilled
hole
Pre-drilled
hole
Locking
device
T-4WCSC153519-0116
