CASE INSTALLATION
Fig. 3 Bolt locations
Multi-Case
1.
Remove any shelves (discard the shelf clips) and/or loose
items from the cases that may interfere with case joining.
Keep all loose items as they will be used later in the instal-
lation process.
2.
Follow the single-case installation instructions for the fi rst
case,excluding #6, then position the next case in the line-
up approximately 3’ away.
3. Move the second case to a position that is approximately
6" from the fi rst case, then position case on the shim
packs.
4.
Push the cases tightly together, then lightly bolt them
together through the holes provided (Fig. 3). Tighten all the
joining bolts until all margins are equal. Be careful not to
over tighten.
C A U T I O N
Installation of 3rd-party materials may result in
diminished case performance.
▲
ELECTRICAL
Electrical hookups are made through the electrical raceway
that can be accessed by removing the rear raceway panel.
For case-to-case wiring, run conduit between the power supply
boxes or run wiring through the raceway. When connecting to
the power supply on the case, fi eld wiring should exit box from
the side furthest away from case wiring to allow more room in-
side for wiring connections. Always check the data tag located
on left end
exterior panel or top interior
of the case. The case
must be grounded.
For more detailed electrical wiring informa-
tion (see Appendix A1).
C A U T I O N
Be certain that all electrical connections are
compliant with local codes.
▲
5.
Repeat steps 3 and 4 of this sequence for all remaining
cases. Be certain to properly level all cases.
6.
Properly align the front panels as needed, then install, if
3.
Install the bumper, if applicable, into pre-attached bumper
track and snap into place.
4.
After suffi cient time has passed to allow for bumper
shrinkage, cut away the excess bumper for fi nal fi t and fi n-
ish. Be certain to use an appropriate cutting tool (tubing-
or PVC-cutter) to ensure a smooth cut.
5.
Install case shelves and reconnect lights with the white
power cord(s) and the heat with the black power cord(s).
Color matching white/black receptacles can be found at
opposite ends of the inside back of the case. Be aware
that differing shelf confi gurations will affect energy con-
sumption and case performance.
Be sure that the T-8
light caps and holders are still positively engaged. Dur-
ing shipping it is possible for these to loosen.
6.
Install toekick back onto the base of case.
applicable, front panel trim (supplied).
7.
Install the bumper into pre-attached bumper track and
snap into place.
8.
After suffi cient time has passed to allow for bumper
shrinkage, cut away the excess bumper for fi nal fi t and fi n-
ish. Be certain to use an appropriate cutting tool (tubing-
or PVC-cutter) to ensure a smooth cut.
9.
Install case shelves and reconnect lights. Be aware that
differing shelf confi gurations will affect energy consump-
tion and case performance.
Be sure that the T-8 light
caps and holders are still positively engaged. During
shipping it is possible for these to loosen.
10.
Install toekick back onto the base of case.
C A U T I O N
Be sure that the T-8 light caps and holders are
still positively engaged. During shipping it is pos-
sible for these to loosen. Prior to install check all
T-8 light connection points prior to installation
and supplying power.
▲
9
Summary of Contents for DELI
Page 2: ...ii ...
Page 5: ...Revision History new manual format_09 21 v ...
Page 23: ...A1 Wiring Information B1 Parts List APPENDIX ...
Page 24: ...A1 WIRING DIAGRAM TBD ...