Features
Affinity® Three Birthing Bed and Affinity® Four Birthing Bed User Manual
(USR025 REV 6)
19
•
Grasp the handles on the side of the foot section mattress, and lift the mattress off the foot section. Or
grasp the pull strap at the end of the mattress and pull the mattress away from the bed.
•
Put the mattress in an applicable location off of the bed.
•
Grasp the foot section by the handle.
•
Raise the end of the foot section up. The foot section will start to slide down under the bed.
•
Lower the back edge of the foot section until it stops.
•
Push the foot section under the bed until it stops.
WARNING:
Make sure the foot section is securely locked in place when you install the mattress. Failure to do so could
cause injury.
To Install:
•
Grasp the handle on the foot section.
•
Pull up on the foot section until it locks into
position.
•
Put the mattress on the foot section.
•
Make sure the mattress catch goes into the foot
section catch.
•
Push the foot end of the mattress down in front of
the handle.
•
Unfold the mattress.
•
Put the foot supports in the applicable position.
OneStep® Foot Supports
The OneStep® Foot Supports can be simultaneously positioned up or down,
through use of the motor powered foot section yoke. This foot section yoke
controls the overall height up and down. Each support can be independently
positioned by using the mechanical release latches at the end of the foot
supports.
To Adjust the Foot Supports:
•
To position the patient’s legs, squeeze the release lever and rotate the
foot support. The foot support rotates upward and outward from 0° to
85°.
•
To return to the storage position, squeeze the release latch again, and
return the supports to the desired position.
The maximum safe working load is 150 lb (68 kg).
OneStep® Foot Supports
Summary of Contents for Affinity Four Birthing Bed
Page 2: ......
Page 8: ...vi Affinity Three Birthing Bed and Affinity Four Birthing Bed User Manual USR025 REV 6...
Page 65: ......
