Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Product Support Team
9
Note:
1.
The supplied interconnecting cable length is 3.75 m. If you need a longer one, ask our technical
support or sales to purchase 5.5 m interconnecting cables；
2.
The inner diameters of the low voltage conduit and the high voltage conduit should be larger
than 30 mm. If there is a high-power peripheral (for authentication) installed on the left pedestal
(according to the picture displayed above), you should increase the inner diameter of the high
voltage conduit；
3.
General burying method: Bury one network cable and one AC power cord for the right pedestal
and bury one network cable and one AC power cord for the central pedestal before installation.
If no AC power cord buried independently, you should bury an AC power cord between the
right pedestal and the central pedestal.；
4.
If you want to bury both of the AC power cord and the low voltage cable at the entrance side,
the two cables should be in separated conduits to avoid interference.；
5.
If all wires of the interconnecting cable have connected with peripherals and more peripherals
are required to connect, you should increase the conduit diameter or bury another conduit for
the external cable；
2.3
Face recognition terminal wiring
Installation Environment:
1.Avoid backlight and direct sunlight.
2. If use barrier outdoors, please install a sun shield over the device.
3.The face recognition device should install on the pedestals of the barriers.
1)
Route the cables through the pipe from top to bottom and thread them through the
cable holes on the barrier pedestal top cover
；
2)
Wiring the RS232 signal cable to barrier controller reserved RS232 interface
