HIKVISION DS-K3B601-L Series, Quick Start Manual

Page: 27 / 38

Swing Barrier
·
Quick Start Guide
19
6. Power on the device again.
The barrier will open automatically and turns back to the closed position. At this circumstance,
the device enters the normal mode.
Note: For details about the DIP switch value and meaning, see Appendix A DIP Switch
Description.
4.2 Pairing Remote Control (Optional)
Purpose:
Pair the remote control to the device through DIP switch to open/close the barrier remotely.
Note: for details about the remote control’s operations, see the related user manual.
Before you start:
Ask our technique supports or sales and buy the remote control.
Steps:
1.
Power off the swing barrier.
2. Set the No.1 switch of the 4-digit DIP Switch on the master lane control board according to the
figure below.
3. Power on the swing barrier and it will enter the pairing mode.
4. Hold the Close button for more than 10 seconds.
The indicator of the remote control will flash twice if the pairing is completed.
5. Set the DIP switch as OFF, and reboot the swing barrier to take effect.
Notes:

You can also pair the remote control via the client software. For details, see Managing
Remote Control in User Manual of iVMS-4200 Client Software.

Only one swing barrier can pair the remote control. If multiple swing barriers are in the
pairing mode, the remote control will select only one of them to pair.

For details about DIP switch value and meaning, see Appendix A DIP Switch Description.
4.3 Initializing Device
Steps:
1. Remove the JP11 jumper cap.
2. Disconnect the power and reboot the device. The device buzzer buzzes a long beep.
3. When the beep stopped, plug the jumper cap back.
4. Disconnect the power and reboot the device.
Note: The initializing of the device will restore all the parameters to the default setting and all
the device events are deleted.
4.4 Switching RS-485/RS-232 Mode
Take the UART2 and UART3 on the main control board as an example. If the Jumper cap’s position