Swing Barrier
·
Quick Start Guide
4
Chapter 3
Wiring
3.1
Components Introduction
Purpose:
By default, basic components of the swing barrier are connected well. You should wire the
pedestals together for communication and wire the swing barrier to the AC electric supply.
Note:
The voltage fluctuation of the electric supply is between 100 VAC and 220 VAC, 50 to 60 Hz.
The picture displayed below describes each component’s position on the swing barrier.
3.2
Wiring Electric Supply
Wire electric supply with the switch in the pedestal. Terminal L and terminal N are on the switch,
while terminal PE should connect to a ground wire (yellow and green wire).
Summary of Contents for DS-K3B601-L Series
