HIKVISION DS-7700NI-SP Series, User Manual

Page: 70 / 185

DS-7700NI-
SP/9000/9600 Series HDVR/NVR User’s Manual
70
2) Select the Post-record time. The post-record time is the time in seconds to also
record after a recording has ended.
3) Enter the Erase Video After. The Erase Video After time denotes the amount of days
that files will be deleted after its initial recording. Setting the time to 0 will allow the
DVR to only delete and overwrite files when the HDD is full.
4) If check the Enable CABAC checkbox, DVR will reduce the bit rate to improve the
quality of image. This feature is supported by analog cameras only.
Note:
You must click the Apply button after adjusting the configuration of each tab before you move on
to adjust another one.
Note:
Event recordings are recordings that are triggered from motion detection and/ or from an
external alarm (See Configuring Alarms and Exceptions on Page 85).
Note:
If an event occurs during Continuous recording, the frame rate will automatically switch to that
set for Event recording.
Note:
For holiday settings, you can refer to Page 55.
Configuring Record Schedule
A record schedule allows you to schedule multiple time periods per day for recording. Setting up
a record schedule will allow you to further conserve disk space by recording only during the time
periods you would like to record at.
Note:
In this chapter, we take the record schedule procedure as an example, and the same procedure
can be applied to configure capture schedule. To setting the capture schedule, choose the
Capture tab in the Schedule interface.
To setup a record schedule:
1.
Enter the Schedule menu, shown in Figure 75 by going to Menu > Recording
Configuration > Schedule.
2.
Select the Record tab to configure record schedule.