Page: 45
7.4
Assigning Radio Detectors
Press the ‘
AZ
’ and scroll to the input number you wish to assign a
wireless detector to:
Press the ‘’
RESET
’ button on the detector you wish to assign to
that particular input.
Ensure that the jumper on the detector PCB is placed in the “EU”
position.
When the detector is assigned, the two dots on the
display with flash.
7.5
Deleting Radio Detectors
Press the ‘
AZ
’ and scroll to the input number you wish to delete.
Press the ‘’
CLEAR
’ button. The dots should have cleared, indicating
the detector has been deleted.
7.6
Display the Signal Strength
The radio expander can monitor the signal of the detectors connected onto the system:
Press the ‘
AZ
’ and scroll to the input number you wish to check.
The display will show the input number and two dots.
Activate the detector and the signal strength will be displayed (0-
99). If it is below 14, use a REPEATER to boost the signal.
7.7
Assigning Repeaters to the Expander
The radio repeaters act as a ‘Range Expander’ and helps a system scale from smaller commercial sites to large
campuses with several buildings.
NOTE
: Repeaters will use an input from the radio expander.
Press the ‘
AZ
’ and scroll to the input number you wish to assign a
repeater. To assign the REPEATER to that input, power the
repeater when the input number is displayed, and one dot will
flash to confirm. To remove a repeater from that input, press
‘CLEAR’
7.8
Supervision Time
The supervision time is the time of monitoring each detector on the radio expander.
Press the ‘
AZ
’ and scroll to the input number you wish to check.
The display will show the input number and two dots.
With the input number displayed, press the
‘MO’
button to
change the supervision time to (a number will be displayed, ignore
this, just follow the dots).
30 minutes (no dots) / 30 hours (1 dot) / 30 days (2 dots)
AZ
1
0
1
0
AZ
1
0
CLEAR
1
0
AZ
1
0
9
6
AZ
0
AZ
1
0
MO
