HIKOKI CR 36DA, Handling Instructions Manual

Page: 16 / 284

16
English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom Possible cause Remedy
Tool doesn’t run No remaining battery power Charge the battery.
Battery isn’t fully installed. Push the battery in until you hear a click.
Tool suddenly stopped Tool was overburdened Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Battery or tool overheated Allow the tool and battery to thoroughly cool.
The trigger switch was held down for 5
minutes or more.
This is not a malfunction.
The motor was automatically stopped to
prevent failure of the tool.
Saw blade
- can’t be attached
- fall off
The shape of the attachment portion doesn’t
match
Use the appropriate blade
(See “Selecting accessories”)
The blade’s attachment hole is worn Replace with a new blade.
Switch can’t be pulled Lock-off button is pushed in Release the Lock-off button.
An abnormal high-pitched
noise occurs when the
trigger switch is pulled.
The trigger switch is being pulled only
slightly.
This is not a malfunction.
It does not occur if the trigger switch is
pulled more fully.
Blade wears out too
quickly.
Number of strokes is too fast
Mode is inappropriate
Switch the mode to a lower setting than the
current one.
(Switch to low speed mode when cutting
stainless pipes)
(See “Adjusting operating speed”)
Proper machine oil not used when cutting
metallic materials
Use machine oil (turbine oil, etc.)
Too much applied pressure during operation During operation, lighten the applied
pressure.
Unable to properly cut. Blade is inappropriate for the quality and
thickness of the material to be cut
Use the proper blade
(See “Selecting accessories”)
Blade is too short for the length of the
material to be cut
Mode is inappropriate for the quality and
thickness of the material to be cut
Set the appropriate mode
(See “Adjusting operating speed”)
Blade is worn, degraded or damaged Replace with a new blade.
Battery cannot be installed Attempting to install a battery other than that
specified for the tool.
Please install a multi volt type battery.
0000Book_CR36DA_EU.indb 16 2019/03/07 18:22:42