17
English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom
Possible cause
Remedy
Tool doesn’t run
No remaining battery power
Charge the battery.
Battery isn’t fully installed.
Push the battery in until you hear a click.
Tool suddenly stopped
Tool was overburdened
Get rid of the problem causing the
overburden.
Overload protection is in operation.
The battery is overheated.
Let the battery cool down.
Cannot be inclined
The incline lever (front) and incline wing nut
(rear) are not loosened.
Try inclining after loosening the incline
lever (front) and incline wing nut (rear).
Tighten the loosened parts after making the
necessary adjustments.
Doesn’t cut well
The saw blade is worn or missing teeth.
Replace with a new saw blade.
The bolt is loose.
Firmly tighten the bolt.
The saw blade is installed backwards.
Install the saw blade in the proper direction.
Switch can’t be pulled
The switch lock is not pushed in enough.
Push the switch lock in all the way.
Sawdust discharge is poor
Sawdust has accumulated in the saw cover. Remove the sawdust inside the saw cover.
Battery cannot be installed Attempting to install a battery other than that
speci
fi
ed for the tool.
Please install a multi volt type battery.
2. Charger
Symptom
Possible cause
Remedy
The charge indicator lamp
is rapidly
fl
ickers purple,
and battery charging
doesn’t begin.
The battery is not inserted all the way.
Insert the battery
fi
rmly.
There is foreign matter in the battery
terminal or where the battery is attached.
Remove the foreign matter.
The charge indicator lamp
blinks red, and battery
charging doesn’t begin.
The battery is not inserted all the way.
Insert the battery
fi
rmly.
The battery is overheated.
If left alone, the battery will automatically
begin charging if its temperature decreases,
but this may reduce battery life. It is
recommended that the battery be cooled in
a well
-
ventilated location away from direct
sunlight before charging it.
Battery usage time is short
even though the battery is
fully charged.
The battery’s life is depleted.
Replace the battery with a new one.
The battery takes a long
time to charge.
The temperature of the battery, the charger,
or the surrounding environment is extremely
low.
Charge the battery indoors or in another
warmer environment.
The charger’s vents are blocked, causing its
internal components to overheat.
Avoid blocking the vents.
The cooling fan is not running.
Contact a HiKOKI Authorized Service
Center for repairs.
The USB power lamp
has switched o
ff
and the
USB device has stopped
charging.
The battery’s capacity has become low.
Replace the battery with one that has
capacity remaining.
Plug the charger’s power plug into an
electric socket.
USB power lamp does not
switch o
ff
even though the
USB device has
fi
nished
charging.
The USB power lamp lights up green to
indicate that USB charging is possible.
This is not a malfunction.
00Book̲C3607DA̲Asia.indb 17
00Book̲C3607DA̲Asia.indb 17
2018/06/15 16:23:26
2018/06/15 16:23:26
