Chapter 1 Installation and Setup 1-21
1
Figure 1-16. High End Systems recommends you replace the CL color correction
filter (at position 4) with the salmon-colored CTO correction filter, and the aqua filter
(at position 5) with the homogenizing frost filter.
Note
Wheel positions are numbered starting at the open hole (position 1). The other seven
positions are numbered counter-clockwise from position 1 when you are facing the color
wheel toward the lamp.
3.
Push the filter you wish to replace toward the center of the wheel to free it from the two wheel
tabs as shown in Figure 1-17:
Figure 1-17. Push the dichroic filter toward the large retaining tab to free it from the
wheel clips.
4.
Once the dichroic is free of the two wheel tabs, pull it out of the wheel. Place the dichroic you
just removed in a safe place where it will not get scratched.
5.
Orient the CTO color corrector so the coated side is facing the lamp, and with the glass side
facing away from the lamp as shown in Figure 1-18. (The smoky-looking homogenizing frost
1
2
3
4
5
6
7
8
Color Wheel
Before
1. Open
2. Red
3. Purple
4. CTO Color Corrector
5. Homogenizing Filter
6. Blue
7. Orange
8. Indigo
Color Wheel
After
1. Open
2. Red
3. Purple
4. CL Color Corrector
5. Aqua
6. Blue
7. Orange
8. Indigo
You will replace
these two dichroics
Open
Summary of Contents for Cyberlight
Page 123: ...C 8 Cyberlight User Manual...
