High End Systems Cyberlight, User Manual

Page: 27 / 147

1-10 Cyberlight User Manual
VIGTIG FIKKER HEDS INFORMATION - DANMARK
ADVARSEI: RESKYTTEKSE MOD ELEKTRISK SHOCK.
VIGTIGT!
LEDERE MED GROEN/GUL ISOLATION
MA KUN TILSLUTTES EN KLEMME MAERKET
ELLER
Setting the Cyberlight
®
Fixture Voltage
The Cyberlight fixture voltage is factory-set to customer requirements. Normally, the factory
setting is correct for your typical use. However, if you change venues and need to change the
fixture’s input voltage, refer to the procedure in this section. (Appendix D has a listing of typical
power requirements worldwide.)
By moving one wire on the power supply board you can set the input voltage to any of the
following:
205 volts 50 hertz 208 volts 60 hertz
230 volts 50 hertz 230 volts 60 hertz
240 volts 50 hertz
Warning Check the voltage selection jumper before proceeding with the equipment
setup! Be sure to match the voltage selection jumper to your power
source prior to operating this equipment. Do not set the voltage selection
jumper with the equipment plugged in.