17
EN
Normally, the dryer should be installed in the middle of the room. To dry a particular spot, install the
dehumidifier in such a way that the air let out is directed on the wet area and the warm, dry air flows
over it. The opening should be at least one metre away from the wall.
The HEYLO/DriEaz dehumidifier heats the air from which it draws out moisture. The temperature in
smaller rooms can increase considerably due to this. Room temperatures between 20° and 27°C
generally provide good conditions for drying. Room temperatures should not exceed 38°C and not be
less than 1°C since the dehumidifier will not work any more otherwise.
4. Assembly before initial start up
Fitting the handle
1.
Remove both screws, right and left on the body (A).
2.
Unscrew the enclosed handle (B).
3.
Fasten the handle in an upright position with the screws (A)
Changing the language in the display
The standard language is English. Follow these steps to change to another language:
1.
Pull out the plug from the mains.
2.
Keep the DISPLAY button (2) pressed down while connecting the device to the mains power
supply. The display now shows “ENGLISH“.
3.
Press the DISPLAY button or the DELETE button to change the display to FRENCH,
GERMAN or SPANISH.
4.
Than the selected setting by pressing the 1 (on / off) to confirm
5.
Next, unplug the device from the mains again. The selected language will then be saved.
CAUTION:
DO NOT use any other buttons! By pressing other buttons while changing the
language mode, it is possible that the operating parameters of the device could
change.
5. Operation
1. Only let the dehumidifier function in an upright position.
2. Connect to a 16 A protective contact socket with the correct voltage and power intensity for the
device.
3.
Turn the switch (1) to ON. After switching on the device conducts a self-test and starts after 60
seconds at the latest.
4.
Check whether the running noise of the fan and compressor is correct, before leaving the unit
unsupervised.
5.
If the device has turned itself off for any reason, wait for five minutes before re-starting it. Damage
to the compressor is thus avoided.
A
B
Summary of Contents for KT 1800
