To replace the component, reverse the removal procedure.
Removing and replacing the non-hot-plug power supply
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
on page 29.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
• Server in rack mode:
Remove the server from the rack
on page 30.
Position the tower server for hardware configuration
on page 31.
7. Remove the system air baffle
8.
Disconnect all power supply cables from the system board, drive cages, and devices
9.
Remove the power supply.
62
Removal and replacement procedures
