3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
Remove the server from the rack
on page 30.
• Server in tower mode:
Position the tower server for hardware configuration
5.
on page 32.
6.
7.
on page 34.
8.
on page 35.
9.
Disconnect the iLO Service Port cable from the system board.
10.
Remove the iLO Service Port cable:
a.
Remove the screw.
b.
Release the cable secured in the cable clip on the chassis.
c.
Pull the iLO Service Port cable away from the front panel.
To replace the component, reverse the removal procedure.
Removing and replacing the serial port cable
Prerequisites
Before you perform this procedure, make sure that you have a 5.0 mm hex nut screwdriver available.
Procedure
on page 29.
2.
Remove all power:
48
Removal and replacement procedures
