3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
Remove the server from the rack
on page 30.
• Server in tower mode:
Position the tower server for hardware configuration
5.
on page 32.
6.
7.
on page 34.
8.
on page 35.
9.
Disconnect the front USB 3.0 ports cable from the system board.
10.
Remove the front panel USB ports cable:
a.
Remove the screws.
b.
Remove the front panel USB ports cable from the front panel.
To replace the component, reverse the removal procedure.
Removing and replacing the iLO Service Port cable
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
Removal and replacement procedures
47
