To replace the component, reverse the removal procedure.
Removing and replacing the four-bay LFF non-hot-plug
drive cage
CAUTION:
To prevent improper cooling and thermal damage, do not operate the enclosure unless
all device bays are populated with either a component or a blank.
Prerequisites
Before you perform this procedure, make sure that you have the T-15 Torx screwdriver available.
Procedure
1.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
Remove the server from the rack
on page 30.
• Server in tower mode:
Position the tower server for hardware configuration
5.
on page 32.
6.
7.
on page 34.
8.
on page 35.
9.
Disconnect all existing drive cables.
52
Removal and replacement procedures
