Technical File
File No.
ZHTF-CE-01-015
Rev. No.
A.5
Non Contact Infrared Body
Thermometer
Instructions for use
Rev. Date
2020-07-10
Page
10 / 19
10
minutes, to be consistent with the ambient temperature after the
re-measurement.
Wait at least 1 second for the next measurement. If the continuous
measurement of five times, it is recommended to wait at least 30 seconds and
then continue measurement.
You cannot use the thermometer in place where the sun is strong.
If for some reason the low forehead temperature measurement can try to align
behind the ears. See figure 3.
General Setup and Use
Start measuring
1.
Turn on the thermometer by pressing the On/Scan button. The
thermometer will perform self-test with all segments displayed for 2
seconds.
2.
Align staff forehead to keep the distance, and then press the On/Scan
button to start the measurement, read the data.
Note:
1)
After full display over, you will hear a rattle or "beep beep beep" three times,
which means that the measurements have been completed, while the target
value of the measured temperature is displayed on the LCD, while backlit
display according to the appropriate setting among the three colors red, green,
yellow one of. And the Green means ready for next measurement. When
37.4
-38.0
, it's yellow ,means slight fever warning. Please pay attention to
body temperature. When the body temperature is above 38.1
, it's red ,
means high fever. Please take action to cool down or go for a doctor.
2)
To ensure the accuracy of the measurement, wait at least 30 seconds after 5
consecutive measurements.
Mode conversion
When the device is running, pressing the MODE button to cycle conversion
between "body" mode and "surface" mode.
"body" mode is used for measuring human body temperature, the "surface " mode
is used to measure the surface temperature. (The factory default is "body" mode).
Figure 3 Align behind the ears to measurement