Vet/IV 2.2
Infusion Pump
13
Section 9: Checking & Adjusting Settings
9.1.1
Check Time Remaining
1. Press
SELECT
once during operation. The remaining infusion time is displayed for 5 seconds.
NOTE:
•
Time remaining is stored even if the pump is switched off.
•
Time remaining will automatically adjust if Total Volume is changed during operation.
•
Time remaining will display as dashes if total time is more than 100 hours.
9.1.2
Check VTBI
1. Press
SELECT
twice during operation. The remaining VTBI is displayed for 5 seconds.
2. When a program is completed, the VTBI will reset to the original programmed volume.
9.1.3
Check VI
1. Press
SELECT
3 times during operation. The volume of fluid that has been administered to
the patient is displayed for 5 seconds.
NOTE:
The VI will automatically reset to zero once it reaches 9,999 ml.
NOTE:
The VI does not automatically reset after the pump is turned off.
When starting with a new
patient, this setting should be cleared and reset to zero during initial setup.
9.1.4
Change Settings During Operation
1. Press
RUN/HOLD
to halt the operation of the pump. [Hold] will appear on the display.
2. Press
SELECT
until the parameter to be changed (Rate, Time or VTBI) is illuminated.
3. Use
or
to change the setting as needed.
4. Press
RUN/HOLD
to resume operation.
9.1.5
Change Alarm Volume
1. Press
ON/OFF
and allow the pump to complete its initial startup phase (
i.e.
, the last rate setting is
displayed).
2. Hold down
SELECT
for approximately 2 seconds, until [Tone] is displayed, then release.
3. Use
or
to adjust the alarm volume. Volume settings range from 1 to 7, with 7 being the
loudest. When the desired setting is reached, press
SELECT
again to return to the main
display.
x 1
x 2
x 3
9.1
Checking & Adjusting Settings