HE 5731 Operating instructions
32
# 373344, Version 1.5
Parameterisation
Note!
The threshold values can be set as required. There is no logical check. If
the values of the lower thresholds are parameterised above the values of
the upper thresholds, the cleaning and pressure display cannot function
as expected.
Note!
Post-cleaning is suppressed as long as precoating is activated.
7.3. Offset for zeroing
1.
Press PARA key.
2.
Use the UP / DOWN keys to select the "Zeroing" parame-
ter.
3.
Confirm with the ENTER key. The display flashes.
4.
Press UP / DOWN simultaneously for 2 seconds. The cur-
rently measured value is inverted and accepted as the off-
set.
5.
If the UP / DOWN keys are pressed independently, the off-
set value can be set manually.
7.4.
Parameterisation with Service PC
When parameterising several devices, parameterisation with a service PC is recom-
mended. The USB / TTL adapter required for this is available from HESCH. The parame-
ters can be changed via PC and the "EasyTool Controls" program. The program can be
used to save a configuration or to restore a saved configuration.
1. Connect the PC to the operating unit via USB cable.
2. Start "EasyTool Controls" to transfer the files or data.
Note!
Instructions for the most important program functions are available at
HESCH.
