Herutu TW-510R, Instruction Manual

Page: 12 / 24

TW-510R
6
4.Outline of operation
4.Outline of operation
Once this machine “TW-510R” receives the signal from “TW-**T”, buzzer sounds and relay
turns on. The contents shown below can be set at your discretion using the setting SW:
・
ID setting
・
Relay output time setting
・
Double count prevention time setting
・
Buzzer sound Effective/Ineffective
If y
ou use the “TW-510R” combined with the “TW-510T”, the receivable ID is one type and the
single antenna type is available. However, as an option for value, the following three types are
also available. Choose the type depending on your application.
Model Antenna Receivable ID
TW-510RD Diversity antenna 1-type(1-unit receiving)
TW-510RW Single antenna 2-type(2-unit receiving)
TW-510RDW Diversity antenna 2-type(2-unit receiving
）
●
1-unit Receiving
“TW-510R” of one unit is used for “TW-510T” of one unit.
“TW-510R” communicates with the Transmitter with the same ID as the one, which was set by
the DIP Switch for setting the ID1.
Once this machine receives a signal, the RX1LED keeps lighting for 0.2 second and it is
outputted to the OUT1 only during the preset output time. If Buzzer output is set at “Effective” at
that time, buzzer sounds in synchronization with the OUT1.
The next receive restarts after the lapse of double counting prevention time after OUT1 output
turns off.
[Outputs from ID1→OUT1]
●
2-unit Receiving Model
：
“RW”
“TW-510RW” of one unit is used for “TW-510T” of two units.
Once “TW-510RW” receives the ID, which was set by the DIP switch for setting ID1,it sends the
signal to OUT1.
If this machine receives the ID, which was set by the DIP Switch for setting ID2, it sends the
signal to OUT2.
Once this machine receives a signal, the RX1LED keeps lighting for 0.2 second and it is
outputted to either OUT1 (ID1) or OUT2 (ID2) only during the preset output time. If Buzzer
output is set at “Effective” at that time, buzzer sounds in synchronization with either OUT1 (ID1)
or OUT2 (ID2).