HER CHEE 2002 ATV-320 S, Service Manual

Page: 79 / 125

Chapter 3 Ignition and Starting System
III-8
Recoil Backup Starting System
CHECK
NOTE
◦ Pull the recoil haft rapidly to have enough
kinetic energy for engine starting.
Park the vehicle on a level ground.
Put the gear shaft to “Neutral”.
Turn the ignition switch “ON”.
Pressed the brake lever then pull the recoil haft.
Repeat about-mentioned process till the engine
starting.
After engine start, release the recoil haft, the wire
should return into the recoil body and the haft
stay to it’s original position.
NOTE
◦ If the recoil haft can’t back to original position,
slightly pull out the recoil wire till it can retract.
If the recoil haft still can’t return to it’s original
position, replace the recoil set.
REMOVAL/INSTALLATION
Remove foot pad.
Loosen five mounting bolts on recoil cover.
Remove recoil set.
Check starting dish edge for wear or damage.
Install the starter motor in the reserve order of
removal.