User Manual Porty L
22
HENSEL-VISIT GmbH & Co. KG
Mains operation with AC Porty mains drawer
During stationary use, the battery flash generator can be
hooked up to the power supply via the mains drawer AC Porty
Li. Instead of the battery pack, the mains adapter is inserted
into the unit
ATTENTION!
Before connecting the AC mains drawer to the power supply,
make sure that the voltage corresponds to the information on
the type label or the values listed in the documentation.
The AC Porty mains drawer must only be connected to grounded
power supplies.
The type label is located at the bottom side of the housing.
The AC mains drawer is equipped with multi-voltage technolo-
gy which means the unit automatically adjusts to the applicable
voltage.
In case of an overheated mains drawer, the control LED
32
lights up.
Â
In this case, switch off the mains adapter and wait until it
has cooled off.
Fuse protection, building
Sockets intended for the connection of an AC mains drawer
must be protected against short circuit with a minimum of 10 A.
AC Porty mains drawer insert
Â
Turn off the
Porty L
with the power switch
18
before remo-
ving the battery pack.
Â
Press the unlocking mechanism
23
on the battery pack and
simultaneously pull out the battery pack from the unit by
pulling it towards the front end of the unit.
Â
Push the mains drawer into the unit until you hear it snap
into place.
Â
Plug the included mains cable into the mains connector
34
and connect the mains plug to the power source.
Â
Use the power switch
28
to switch on the mains adapter.
The LED
POWER 30
lights up.
