User Manual Porty L
8
HENSEL-VISIT GmbH & Co. KG
3 Safety instructions
In addition to the general rules for handling electrical equip-
ment, the following safety precautions must be observed.
Read and observe the below listed information before initial
operation of the equipment.
Supply a copy of the safety precautions when selling, leasing, or
otherwise distributing this equipment.
ATTENTION!
Improper handling of the device, non-compliance with the safety
hints below, or tampering with the safety features can cause
property damage, bodily injury, electric shock, or even death.
The rechargeable flash generator
Porty L
is intended for pro-
fessional use inside the studio. Its purpose is the supply of
electrical energy for specified types of flash heads. The flash
generator is to be used only with the accessories described in
this manual and approved by Hensel-Visit.
The
Strobe Wizard Plus
transmitter, the
freemask
transmitter
and
Profoto Air
are used for triggering flashes and adjusting
the flash output of Hensel-Visit flash units with built-in receiver
via radio signal.
The appliance may not be used for any other purpose than
described above, especially not for other electrical applications.
Set-up and initial operation
•
Do not use flash units in explosive environments.
•
Before connecting the AC mains drawer to the power sup-
ply, make sure that the mains voltage corresponds to the
specifications listed on the unit’s specification plate.
•
The
Porty
with AC mains drawer must only be connected to
grounded power supply systems.
•
Check the protective conductor function of the power supply
before initial use.
Normal Use
Abnormal use
