User manual Integra Mini 300
11
HENSEL-VISIT International GmbH
7 Initial use
ATTENTION!
Please make sure that the unit is not connected to any power
supply when preparing for initial use.
Acclimatization
When relocating the device from and to locations with marked
temperature differences, place the unit inside the room where
it is to be used and first let it sit for some time. This prevents
moisture built-up which can cause creeping currents.
Removal of transport cap
The transport cap protects the flash tube / protective glass cover
during transport and when stored without a reflector.
Â
Push the locking mechanism of the reflector holder
7
against
the spring resistance up to the arrester.
Â
Pull the protective transport cap straight out from the holder.
ATTENTION!
Do not switch on the device when the transport cap is attached.
The heat development of the modeling light could cause a fire.
Protective glass cover
ATTENTION!
Make sure that the flash tube and modeling light do not become
damaged during installation or removal.
The protective glass cover snaps into place via three pre-moun-
ted springs.
Â
Tilt the protective glass cover slightly and insert it into one of
the springs.
Â
Then snap the protective glass cover into the second spring
by applying light pressure, and continue this procedure until
it snaps securely into the third spring.
Mount
Summary of Contents for Integra Mini 300
Page 1: ...Integra Mini 300 Kompaktblitzgerät Compact flash ...
Page 31: ......
