Hensel Expert Pro, User Manual

Page: 20 / 30

User manual // Expert / Integra Pro (Plus)
20
HENSEL-VISIT International GmbH
Safety instructions
Changing this unit is strictly prohibited. The housing is
splash-proof but not watertight. Therefore protect the
equipment from humidity. The operation during rain is
not recommended because over the years moisture
might ingress into the housing causing damage to the
electronics.
Start-up and channel selection
– receiver –
For operation with compact flash units of the Expert /
Integra Pro series without built-in receiver the external
receiver is to be attached to the synchronization socket
7 of the compact flash unit. After switching the unit ON
using the main switch 1 , the green LED 28 of the
receiver is flashing. For channel selection, the lateral
sliding switch
27 of the receiver is used. In total, 3
working channels are available. For channel setting,
please refer to the figure on page 1 of this manual. By
pressing the RC button
2 the built-in receiver of the
Plus versions of the Expert /Integra Pro series is
switched on. The channel can be selected by pressing
the flash control switch
13 once. By turning the knob,
channels from 1 to 3 can be selected as shown on the
LED display
14 . After 3 seconds delay the channel is
set and the display changes to the flash power setting.
Start-up and channel selection
– transmitter –
The radio transmitter has no built-in main switch for
switching the unit ON. The transmitter is to be
connected to the camera either by attaching it to the hot
shoe of the camera or by connecting the camera to the
synchronization
socket 24 using the provided
synchronization cable. If the transmitter is connected to
the hot shoe the unit must be tightened carefully using
the locking screw
25 . The working channel can be
selected using the sliding switch 22 . There are 3
working channels available and the option „All‟.
Flash triggering
Depending on the working channel selected the flash
can be triggered by pressing the „TEST‟ button
23 or by
releasing the camera shutter.
7:
SYNC
1, 28
27
2:
RC
13, 14
24
22, 25
23