Hensel Expert Pro, User Manual

Page: 15 / 30

User manual // Expert / Integra Pro (Plus)
HENSEL-VISIT International GmbH
15
Mains connection
Attention:
Before connecting the compact flash unit to the mains
outlet, make sure that the mains voltage matches the
information given on the type label of the compact
flash. The type label can be found on the bottom of the
appliance. All Expert Pro compact flash units are only
for 230V/ 50-60 Hz operation.
The Integra Pro series comes with multivoltage
technology, i.e. the compact flash adjusts itself for
different main voltages.
The provided power cable has to be led through the
handle, then attached to the mains socket
10 and
connected to the mains outlet. Use the cable fixation 15
for allowing unhindered tilting of the unit.
Compact flashes must only be connected to mains
outlets with ground connection.
Fuses
Outlets in the building
Minimum requirement
10 A fuse outlets
Fuses of the compact flash unit
The fuse
9 is a general fuse for the compact flash unit
and the modeling lamp. All units of the Expert Pro
series (only for 230V operation) come with a fuse 2 A
fast (
2 AF ). All units of the Integra Pro series
(multivoltage technology) come with a fuse 4 A fast ( 4
AF ).
The specification of the fuses mentioned above is valid
for operation with modeling light 300 W halogen.
For more information, please refer to page 38,
Replace-
ment of fuses .
Overheating
All Expert / Integra Pro units are equipped with a fan to
avoid overheating with fast flash sequences, which
could cause damage to the flash tube and the compact
flash unit. Nevertheless, if overheating occurs, the error
<E1> is displayed on the LED
14 . After a break for
10, 15
10 A
9:
2 AF
4 AF
14:
<E1>