HENR
Y
T
OOLS,
INC.
Ph:
(216) 291-1011 or (800) 826-5257
General Operators Instructions and Service Manual
www.HenryTools.com | Page 180
Revised 12/10/15
For additional product information visit our website.
PRODUCT SAFETY INFORMATION - WHEN
USING THE TOOL:(CONTINUED)
Additional Warnings for Use of Cut-off Wheels (Type 1 and 27A)
• When cutting, support the workpiece so the slot is kept at
constant or increasing width during the whole operation.
• If the abrasive product gets jammed in a cut slot, shut off
the grinder and ease the wheel free. Check that the wheel is
still correctly secured and not damaged before continuing the
operation.
• A cut-off wheel shall not be used for side grinding. The 6 &
11 cup wheels remove large amounts of metal and are good
for open spaces. Use a Type 27 & 28 wheel for weld grinding,
notch and gate removal, pipe beveling and repair or in metal
fabrication, petrochemical maintenance or construction. After
mounting a wheel or other abrasive accessory, the Grinder
SHALL
be run in a protected enclosure or under a work
bench, at a gradually increasing speed, for at least 60 seconds.
Make certain no one is in front of or in line with the wheel or
other abrasive accessory. Be aware that it may fail at this time
if it is defective, improperly mounted or the wrong size and
speed.
STOP IMMEDIATELY
if considerable vibration or other
defects are detected. Shut off the air supply and determine the
cause.
Your selection and purchase of finishing tools has a direct effect
on process and product quality. Your decision can make a dif-
ference in finishing efficiency and in the improved quality and
durability of finishes. Only use recommended equipment and
adaptors. Inspect grinding wheels closely for any imperfections,
damage or broken edges. Use correct size guards, flanges,
blotters, spindles and mounting practices to ensure operator
safety. All give you the ability to match capacity and attach-
ment precisely to the work piece and material for finessing a
high quality finish
MODELS
56 VL
56 VS
