HENR
Y
T
OOLS,
INC.
Ph:
(216) 291-1011 or (800) 826-5257
Type 11 Wheel Mounting
(CUP WHEELS)
General Operators Instructions and Service Manual
www.HenryTools.com | Page 176
Revised 12/10/15
For additional product information visit our website.
General Wheel Mounting Instructions
Wheels known to have been subjected to improper mounting procedures
can burst violently and should be destroyed rather than risk their use by
someone who may not notice that the wheels are damaged.
Note: The grinding wheel shown above has threaded hub.
Your new Vertical grinder flanges must be flat, not relieved, and free of nicks or burrs. Flanges for Type 6 or 11
wheels must be at least 1/3 the wheel diameter. Always use wheel retainer supplied by manufacturer on Type 6 or I1
wheels(CupWheels). When using depressed center wheels, only use adapters supplied by the manufacturer unless they
are furnished as a part of the wheel. Do not reuse throwaway adapters attached to depressed center wheels by the
manufacturer. Spindles must not be bent and threads must be free of any damage that might keep a wheel from being
centrally mounted or seated properly against driving flange. Wheel must be sufficiently tightened to prevent spin-off.
Before using or after mounting wheel, the tool must be run for one minute in a protected enclosure to check integrity of
the wheel.
WARNING
: FRAGMENTS FROM AN ABRASIVE
WHEEL THAT BREAKS OR COMES APART WHILE
ROTATiNG CAN CAUSE SERIOUS INJURY OR EVEN
DEATH.
NEVER
OPERATE A WHEEL TYPE GRINDER
WITHOUT A GUARD.
Cup wheels are mounted directly onto
the tool. No additional accessories are
required.
Type 27, 28 or 29 Depressed center wheels can be mounted as shown below.
Note: the 650-60 is shipped STANDARD on your Vertical Grinder.
INSPECT THE WHEEL OR ACCESSORY
Check the maximum safe RPM marked on the wheel or accessory. Never use a wheel or accessory rated below the actual
tool speed. Cracked, dropped, faulty, or bent accessories are dangerous. Suspect accessories should not be used and
should be disposed of. Inspect wheel for cracks or chips, water stains, or signs of abuse or improper storage Cracked or
faulty grinding wheels are dangerous. They must be destroyed rather than risk their use by someone who may not notice
that they are damaged.
MODELS
56 VL
56 VS
