Alternate Mounting
If the wheel has a protruding outer hub which will not permit
the use of the pressure cup, or the cup will not permit the hub
nut to engage at least four turns of the arbor, this alternate
method should be used.
1.
Place the cone spring on the arbor with the large end
towards the balancer.
2.
Select the cone that best fits the center hole in the wheel.
Slide the cone onto the arbor with the large end towards the
spring.
3.
Lift the wheel onto the arbor and center it on the cone.
4.
Use the small nylon spacer (no-mar ring) or a centering
cone to press against the outer wheel hub.
5.
Spin the hub nut (without the pressure cup) onto the arbor.
Tighten securely
Optional Combi-Adapter Mounting
Use this method for wheels without a center hole, for a cen-
ter hole that is out of round, or center holes that do not fit the
mounting cones. This adapter allows the mounting of 3, 4, 5, 6,
8, or 10 lug wheels by installing 3, 4, or 5 swivel plates on the
adapter plate.
1.
Assemble the adapter according to the instructions pro-
vided.
2.
Attach the adapter to the wheel. The lug nuts must properly
seat in the lug holes and engage at least four full threads for a
secure mounting. Use the wrench provided with the adapter,
and never use air tools or impact wrenches.
3.
Remove the threaded arbor (if necessary for wheels with-
out a center hole).
4.
Lift the wheel onto the balancer and align the adapter base
plate studs with the holes in the arbor faceplate. Secure the
adapter/wheel to the faceplate using the thumbnuts. To properly
center the wheel, tighten the thumbnuts in an alternating pat-
tern while rotating the wheel.
Direct Drive
COATS 1000/1000D Wheel Balancer • 9
Figure 12 - Alternate Mounting
Figure 13 - Optional Combi-Adapter
Spring
Cone
No Mar Ring
Hub Nut
Swivel Plate
Swivel Plate Bolt
Washer
(optional)
Faceplate
Nut
Number
Gear
Center
Bushing
Alignment
Mark
Combi Plate
Alignment
