16.
Loosen the four 5/16" nuts and raise the control pod sup-
port arm. Raise it high enough to allow room for the pod to
rotate into position and for the Match Mount instructions to
lower below the pod.
17.
Lightly tighten the control pod support arm retainer nuts
on the side of the support bracket. Arm will be adjusted and
tightened later.
18.
Loosen the two adjustment knobs on the back of the
control pod (Figure 6).
19.
Rotate the pod into operating position, and retighten the
knobs.
20.
Loosen the nuts on the support arm retainers. Raise or
lower the control pod into the desired position, and tighten the
retainer nuts securely. The bottom edge of the pod should be at
least 8 inches above the top of the balancer (Figure 7).
21.
Lower the Match Mount instructions attached to the
underside of the control pod. If there is not enough room
between the pod and the balancer weight tray to fully lower the
instruction card, the pod should be raised.
22.
Position the balancer in its final operating location.
Lightly tighten the four 5/16" nuts
23.
Install the wheel caliper hook on the outside of the hood
(away from the balancer). Remove the 1/4" screw (towards the
rear of the hood), position the caliper hook over the hole, and
reinstall the screw.
24.
Install the side pocket (1050 standard, 950 optional) and
accessory peg brackets/covers (950 and 1050 standard).
Mounting holes are provided on the side and rear of the bal-
ancer to allow the pockets and peg brackets to be installed
according to user requirements. Mount up to three side pock-
ets or two peg brackets on the side or the rear. Contact your
Hennessy Representative to order additional pockets or brack-
ets.
Direct Drive
4 • COATS 1000/1000D Wheel Balancer
Figure 6 - Control Pod Adjustment Knobs
Figure 7 - Control Pod Height
8" Min.
Adjustment Knobs
