Please Note
The original language of these instructions are English.
The airborne noise of the system under normal operating conditions
does not exceed 70dB (A).
General Safety Precautions
This installation is intended for professionally competent personnel
only.
Installation, Electrical connections and adjustments must be performed
in accordance with Good Working Methods and in compliance with
applicable regulations. Before installing the product, carefully read the
instructions. Bad Installation could be hazardous.
The packaging material (plastic, polystyrene, etc.) should not be
discarded in the environment or left within the reach of children, as
these are a potential source of hazard.
Before installing the product, make sure it is in perfect condition.
Do not install the product, make sure it is in perfect condition. Do not
install the product in an explosive environment and atmosphere; gas or
inflammable fumes are a serious risk hazard. Before installing the
system, ensure all structural changes relating to safety clearances and
protection or segregation of all areas where there is a risk of being
crushed, cut or dragged, and danger areas in general.
Make sure the existing structure is up to standard in terms of strength
and stability.
Each installation must clearly show the identification details of the
motorized door or gate.
Apply hazard area notices required by applicable regulations.
The electricity supply must be isolated at tis source before attempting
installation or maintenance.
Disclaimer
PC Henderson nor the motor unit manufacturer take responsibility for
failure to use Good Working Methods in building the frames to be
motorized or for any deformation occurring during use. PC Henderson
and the motor declines all responsibility in the event of component
parts being fitted that are not compatible with the safe and correct
operation.
For repairs or replacements of products only original spare parts must
be used.
Installer responsibility
The installer should provide technical documentation once the
installation is complete, this should include.
-
EC declaration of conformity with machinery directive
-
Installation manual
-
Maintenance / Trouble shooting guide (supplied in the drive
unit manufacturer operation manual)
-
The installer is responsible for affixing final CE mark upon
the installation.
668775 – LVL02 – JUNE 2019
Tighten to position stops
