Hemisphere GPS LiteStar II Air, User Manual

Page: 34 / 135

LiteStar II Air User Guide
25
3. Use the length taken in Step 2 and tie-off excess cable length if
required.
4. Run the cable from the controller to the spray system.
5. Connect the end of the cable to the vehicle spray system using
the supplied spray leaf-spring switch (Part No. 075-4001). A
closed connection means spray is ON and an open connection
means the spray is OFF.
To connect the GPS receiver/antenna cable:
1. Find the cable labeled either “051-0056” or “051-0053,”
depending on your receiver type.
2. Measure the distance between the receiver and the location of
the controller inside the cab.
3. Use the length taken in Step 2 and tie-off excess cable length if
required.
4. Connect one end of the cable to the receiver.
5. Run the cable from the receiver to the controller.
6. Connect the other end of the cable to the outlet on the
controller labeled “GPS.”
Tip! To connect the cable: plug the cable into the outlet and
turn the ring on the plug connector to tighten.
Note: The cable is designed to withstand all types of
conditions and can be installed inside or outside the vehicle.
WARNING!
Finger-tighten the cable connectors. Do not use any tools.
LiteStar II Air.book Page 25 Thursday, June 7, 2007 4:02 PM