6
Disassembly
1. To disassemble, ENSURE POWER IS SWITCHED OFF at the main circuit breaker AND ALL BUTTON
BACKLIGHTS ARE OFF.
2.
To remove the HE-TPS04 touch panel unit, grasp firmly at the bottom and pull backwards while tilting outwards
until all tabs are disconnected.
3. Remove screws from backplate and disconnect the wires by inserting a small Phillips-head screwdriver into the
slot beneath of each wire and turning counter-clockwise to release.
Factory Reset
To reset the HE-TPS04 to factory defaults, simultaneously press the two bottom buttons and hold for 6 seconds. If
successful, all buttons will turn OFF then the device will reboot.
The factory reset will change all the Parameters to their original factory default values (including Z-Wave frequency) and
will also Exclude the device from any Z-Wave network.
Note:
Please use Factory Reset only when the primary network controller is missing or otherwise inoperable.
Z-Wave Network
The HE-TPS04 may be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers.
The HELTUN HE-TPS04
will act as a ‘repeater’ (i.e. ‘range extender’) for other devices regardless of manufacturer or
brand to increase the reliability of the overall network.
Adding to Z-Wave network
To add the HE-TPS04 into a Z-Wave network
(i.e. “Inclusion”), do the following:
1. Start the Inclusion Mode from the gateway/controller.
2. To start the inclusion process on the HE-TPS04, simultaneously press the two upper touch buttons and hold them for
three seconds.
3. All buttons will then sequentially blink blue
– red.
4. If the inclusion has been successful, all buttons will turn blue for three seconds.
5. If the inclusion was not successful, all buttons will turn red for three seconds. In that case repeat the inclusion process.
Note:
For correct operating in Fibaro gateways, the Single Channel Association should be removed from the device
LifeLine (EndPoint 0 Group 1).
Removing from Z-Wave network
To remove the HE-TPS04 from a Z-Wave network
(i.e. “Exclusion”), do the following:
1. Start the Exclusion Mode from the gateway/controller.
2. To start the exclusion process on the HE-TPS04, simultaneously press the two upper touch buttons and hold them
for three seconds.
3. All buttons will sequentially blink blue - red.
4. If the exclusion has been successful, all buttons will turn red for three seconds.
5. If the exclusion was not successful, all buttons will turn blue for three seconds. In that case repeat the exclusion
process.
Note:
If the HE-TPS04 has previously been part of a Z-Wave network and
has not been Excluded since, inclusion is not possible without first
performing an Exclusion or Factory Reset procedure.
Security
S0, S2 unauthorized, and S2 authorized Inclusion Modes are supported. If
you use the S2 authorized Inclusion Mode the security key should be used
during the inclusion process. Security key is the first 5 digits of DSK
(
device
DSK is printed on the HE-TPS04 back panel plus on the Security Card
included in the packaging).
Note:
Be sure to save this key. Without the key, it is impossible to perform
an inclusion in S2 authorized mode.
